INFORMATION DATA WHEN CHOOSING EQUIPMENT
	Level measurement of liquid and bulk
	a) Data about the fluid to be measured:
	- what is the fluid and its concentration___________________________________
	- product temperature : min.___________ max.____________
	- pressure range: min.______________ max.______________bar
	- dielectric constant of the product, Er___________
	- product specific gravity:__________________
	- product built-up on probes is likely to occur? Y - N -
	- for liquids only:
		viscosity at working temperature:_________centipoise
		conductivity:__________________
		solidification is possible? Y - N -
		foam is likely to occur? Y - N -
		waves on surface? Y - N -
		highly volatile? Y - N -
	- for bulk products only:
		dry -  or humed -   ?
		high powder -   or coarse pellets -
	b) Vessel data:
	- walls material:_________________________________________________________
	- vessel is open  -   or sealed -
	- vessel dimensions:_______________X______________X______mm (attach drawing)
	- filling / discharge nozzles position (attach drawing)
	- fittings available for level device:
		flange_____________________
		thread_____________________
		pipe_______________________
	c) Device requirements:
	- mounting position :
		side
		top
		bottom
	- continues level measurement -     or level switch -    ?
	- enclosure protection  IP ___________________or Explosion class____________
	- for continous measurement only:
		level range _________mm (attach drawing)
		accuracy___________%FS
		- dasplay
		local -
		remote -
		- outputs:
		4-20 mA
		serial 232/485 or Hart/Fieldbus
		limit switches:____________________________
	- for point measurement only:
		number of points:____________________
		length from mounting position to switching point:________mm
		output type: relay - ; PNP - ; NPN - ; 2 wire AC -
		output status in presence of product: NO -, NC - , SPDT -