INFORMATION DATA WHEN CHOOSING EQUIPMENT
	Flowmeters
	a) Data about the fluid to be measured:
	- what is the fluid and its concentration___________________________________
	- flow range required: volumetric__________liters/hour, masic_______kg/h
	- fluid pressure: min.__________________ max.____________________bar
	- fluid temperature: min.______________ max._______________
	- viscosity at the above temperatures____________________________centipoise
	- fluid conductivity__________________________(for liquids only)
	- fluid density at working conditions: ____________________________kg/m3
	- is the fluid transparent? Y - N -
	- is the fluid abrasive ? Y - N - . If yes, percent of solids in liquid is ____________ and  their
	size range_______________
	- is it corrosive? Y - N - pH value________________
	- is fluid solidification possible? Y - N -
	b) Piping data:
	- pipe size: ___________________mm
	- piping orientation:
	vertical
	horizontal
	- straight pipe length before flowmeter: ______________m
	- straight pipe length after flowmeter: ______________m
	- is the pipe full with fluid (for liquids only)? Y - N -
	- piping connection:
	flange___________
	thread___________
	sanitary_________
	c) Meter requirements:
	- flowrate measurement -
	- totalizer -
	accuracy___________%FS
	- dasplay
	local -
	remote -
	- outputs:
	4-20 mA
	serial 232/485 or Hart/Fieldbus
	limit switches:____________________________
	- environmental requirements: IP__________ / Explosion class____________